USA 800-366-9709 / +1-404-794-8110
 
 

Flow Control Parts

An original Endura flow control is essential to the proper operation of your Endura grease interceptor. The flow control limits the unit to its rated capacity allowing enough time for grease separation to take place inside the interceptor. The flow control fitting is molded in PVC and must be solvent welded using PVC or PVC/ABS transition cement as appropriate. It is to be located in the drain line beyond the last connection from the fixture and as close as possible to the underside of the lowest fixture. When the discharge from two or more sinks or fixtures are combined and served by one interceptor, a single flow control fitting should be used. The flow control device can be recessed into the floor if required and extension sleeves are available to complete a good finish at final floor level.
Compact Spigot Flow Controls

Compact Spigot Flow Controls
5 parts, click on image
Compact Threaded Flow Controls

Compact Threaded Flow Controls
5 parts, click on image
Compact Flow Controls

Compact Flow Controls
3 parts, click on image
Extension Kits, Flow Controls

Extension Kits, Flow Controls
2 parts, click on image
Flow Control 2"

Flow Control 2"
25 parts, click on image
Flow Control Spigot 2"

Flow Control Spigot 2"
9 parts, click on image
Flow Control Threaded 2"

Flow Control Threaded 2"
10 parts, click on image
Flow Control 3"

Flow Control 3"
8 parts, click on image
Flow Control Spigot 3"

Flow Control Spigot 3"
2 parts, click on image
Flow Control Threaded 3"

Flow Control Threaded 3"
2 parts, click on image
Flow Control 4"

Flow Control 4"
7 parts, click on image
Flow Control Spigot 4"

Flow Control Spigot 4"
2 parts, click on image
Flow Control Threaded 4"

Flow Control Threaded 4"
2 parts, click on image